Pin Holes in Fuel Tank (Sorted)

[spookefoote1956]

Hello again. Some of you may have been following my project kate thread. The tank is structurally finished but has a few, well thirteen, tiny holes which showed up when pressure tested.

Should I:- (Me and Brother Albert)

Apply more mig weld, dress off

Silver solder although I think the heat would warp the structure

Lead solder with iron

Fill it full of POR (other goos are available) and hope for the best

Or something else?

Cheers, Chris

[cbranni]

Mig it

Colin

[Mick D]

MIG - No other considerations necessary - the tank is still bare metal so no excuses not to do it properly.

Regards Mick

[spookefoote1956]

Mig it is then!

[bitza]

You have made a cracking job so far a bit more time mig welding the pin holes and dressing them up, shame to spoil the ship, you'l
Get there. Been down that road many a time when I was in the fabrication game.