Does anyone know what the bracket holding the exhaust pipe to the frame looks like? And if possible the dimensions as I am missing the one on my `bike.
Cheers, basketcase.
G2CSR Exhaust pipe bracket
-
- Posts: 141
- Joined: Sat Jan 15, 2005 12:00 am
- Location: STAFFORDSHIRE UK
-
- Member
- Posts: 77
- Joined: Fri Aug 20, 2004 1:00 am
- Location: CHESHIRE UK
G2CSR Exhaust pipe bracket
hi,
on my g2, the front exhaust has a stud welded or brazed on, and it fits into a bracket from the frame,and is then held solid with a nut and washer.
regards, alan.
on my g2, the front exhaust has a stud welded or brazed on, and it fits into a bracket from the frame,and is then held solid with a nut and washer.
regards, alan.
-
- Member
- Posts: 77
- Joined: Fri Aug 20, 2004 1:00 am
- Location: CHESHIRE UK
-
- Member
- Posts: 77
- Joined: Fri Aug 20, 2004 1:00 am
- Location: CHESHIRE UK
G2CSR Exhaust pipe bracket
sorry disregard my above post, i should have read it properly first.
if you dont get the answer you need, i will go in the shed tommorrow and have a look, or try and take a photo if you want one.
regards, alan.
if you dont get the answer you need, i will go in the shed tommorrow and have a look, or try and take a photo if you want one.
regards, alan.
-
- Posts: 141
- Joined: Sat Jan 15, 2005 12:00 am
- Location: STAFFORDSHIRE UK
G2CSR Exhaust pipe bracket
Yes there is a stud brazed on, but buying the bike as a "basketcase" and never before having seen one, I`ve no idea what it looks like. The exhaust is a new one bought from Armours, a really good fit. If you wouldn`t mind, either the measurements or a description would be fine, there`s no hurry as I`m away for a week as from Monday.
Cheers, basketcase.
Cheers, basketcase.
-
- Member
- Posts: 77
- Joined: Fri Aug 20, 2004 1:00 am
- Location: CHESHIRE UK
G2CSR Exhaust pipe bracket
hi basketcase,
it is just a "z" shaped bracket about 1/2 inch wide, 1/8 inch thick, drilled through at both ends, exhaust stud goes through one and a bottom engine mounting stud goes through the other end.
regards, alan
it is just a "z" shaped bracket about 1/2 inch wide, 1/8 inch thick, drilled through at both ends, exhaust stud goes through one and a bottom engine mounting stud goes through the other end.
regards, alan
- Biscuit
- Deceased
- Posts: 3924
- Joined: Thu Jan 01, 1998 12:00 am
- Location: KENT UK
G2CSR Exhaust pipe bracket
Having just struck up an aquaintance with one of these er, bikes, the bracket is a piece of flat MS. 0.8" wide by 0.2" thick, each end is bent at right angles in opposite directions (like half a swastika) the centre portion is 2.9" long, the right angled bit that bolts to the engine stud is 7/8ths" from centre of middle portion to bolt hole, and the bit that bolts to the pipe is 0.95" ditto. The engine stud to which it is secured is the one directly below the points housing.
Not saying this is necessarily correct, but it is what is fitted to the bike in question.
Not saying this is necessarily correct, but it is what is fitted to the bike in question.