Re G2 CSR head bearings

Information relating to the Matchless G2 or AJS Model 14 250cc Lightweight
Posts: 141
Joined: Sat Jan 15, 2005 12:00 am
Location: STAFFORDSHIRE UK

Re G2 CSR head bearings

Postby basketcase » Sun Mar 09, 2008 5:56 pm

I`ve solved the problem concerning the head bearings.....the cups were in the wrong way round. They wouldn`t fit, until a tad was ground off where it touched the down tube. I know it sounds a bit `Heath Robinson` but it works!!

Problem 2 arose when fitting everything back together, upon tightening the nuts holding the caps on the bottom of the forks, CRACK!!. I now have a lovely split in the r/h leg up to the drain plug. Will I be able to alloy weld it or am I best sourcing a replacement?

Who mentioned `long term project`?!?

Basketcase.

Member
Posts: 2105
Joined: Wed Oct 12, 2005 9:45 pm
Location: N YORKS UK

Re G2 CSR head bearings

Postby 56G80S » Sun Mar 09, 2008 9:35 pm

I've had welding done on these, but not in that location, for me it was a split in the mudguard lug , opposite side to the brake anchor, and it's worked fine. But I have to say that Flavell's, the local firm that did it, had a top class reputation and long experience of alloy welding.

Where yours is sounds like a different kettle of fish altogether. It would make me nervous.

Good Luck

Johnny B

Return to G2 / Model 14

Who is online

Users browsing this forum: No registered users and 5 guests