Engine Oil AJS 250

Information relating to the Matchless G2 or AJS Model 14 250cc Lightweight
Locked
knighti
Posts: 7
Joined: Wed Mar 16, 2011 6:16 pm
Location: Kent UK

Engine Oil AJS 250

Post by knighti »

I understand the engine oil copasity for the 250 is 2.5 pints. Is there a way to check what is in the sump before toppong up.Or is it a drain and refill?

cheers
John
User avatar
Tolly
Member
Posts: 647
Joined: Mon Jan 01, 2001 12:00 am
Location: KENT UK

Engine Oil AJS 250

Post by Tolly »

You should be able to see the oil level if you take the filler cap off. When was the oil last changed? If you're not sure drain and refill. When you fill up make sure the level is about 1 inch below the little return hole, you should be able to see this just below the filler hole. Just a little advise, check the gearbox oil also and make sure this is always topped up full. It's been mentioned on here many times that if you let the gearbox oil go a little low the gears don't pick it up as they are situated in the top of the box and you knacker the box if it's a little low on oil.
_______________________________________________________

Experience is something you don't get until just after you need it.
User avatar
BigAl350
Posts: 154
Joined: Sat May 22, 2010 4:32 pm
Location: BERKSHIRE UK

Engine Oil AJS 250

Post by BigAl350 »

Sorry but this is not quite correct - the engine oil level should be 1 inch below the FILLER CAP ORIFICE, NOT below the return hole! You'll find that the correct oil level is usually about the same level as the return hole. I use an old, wooden lolly stick with a mark on it to check the level.

Full information about oils, etc, is contained in the owner's manual, which can be downloaded from the archives.

It is indeed VITALLY important to check the gearbox oil level very regularly, especially if it leaks, like they all do!

Use straight SAE 30, 40 or 50 oil, not multigrade and change it regularly too - the oil in the Lightweights runs very hot as there's not much of it and it's kept nice and warm as it nestles inside the engine cover. Clean the oil filter too at regular intervals.

Al

quote:
You should be able to see the oil level if you take the filler cap off. When was the oil last changed? If you're not sure drain and refill. When you fill up make sure the level is about 1 inch below the little return hole, you should be able to see this just below the filler hole. Just a little advise, check the gearbox oil also and make sure this is always topped up full. It's been mentioned on here many times that if you let the gearbox oil go a little low the gears don't pick it up as they are situated in the top of the box and you knacker te box if it's a little low on oil.
Edited by - BigAl350 on 26 Feb 2012 11:44:49 PM
Al Bolton, G4VSQ
1960 Matchless G5 (Off the road for now, maybe for sale?)
1960 AJS Model 8 (Just passed MoT)
1962 AJS Model 8 (Still lurking in a Devon shed in bits)
User avatar
SideValve
Posts: 189
Joined: Wed Jan 05, 2011 10:37 pm
Location: OXON UK

Engine Oil AJS 250

Post by SideValve »

If you mean oil thats in the crankcase - nope, if you think there might be a significant amount just run the engine until the level stabilises then top up. Or drain everything and start from scratch.
Peter W
tinhat
Posts: 7
Joined: Wed Oct 12, 2005 10:45 pm
Location: HERTS UK

Engine Oil AJS 250

Post by tinhat »

All advice above very good stuff but its always usefull to have the correct Handbook as a good starting point.
Oil system is dry sump , so unless the motorcycle has been standing for a long while there should be very little in the (true) sump
What you can see when you take the oil filler cap off is in actual fact an oil tank that is part of the crankcases/engine cases, it is seperate from the sump.
Once the engine is run the oil that is in the sump (it may have drained there whilst the engine was standing) is scavenged by the pump and returned to the oil tank. If you watch the small hole about one inch down in the oil tank you will see the oil being returned, this is usually an intermittant flow, when everything is working OK. this is when the level should be checked in the tank.
DO NOT fill the tank up unless you have started the engine and made sure that the return to the tank is intermittant. If you do you will probably overfill the engine which is NOT GOOD.
TH
Locked