Hi All, just need some advice.
Putting back together my 1956 G3LS. Question is found a steel spacer in the engine breather hole which houses the release valve (00836). The spacer doesn't show up on the Spares list for this valve, but does on the engine oil feed side (015528). Should it be there?
Release Valve
- chappers1962
- Member
- Posts: 159
- Joined: Mon Dec 17, 2018 8:50 pm
- Location: UK
Release Valve
You do not have the required permissions to view the files attached to this post.
- ajscomboman
- Member
- Posts: 3981
- Joined: Mon Jan 01, 1990 12:00 am
- Location: HAMPSHIRE UK
Re: Release Valve
Yes it's for the oil feed union.
- chappers1962
- Member
- Posts: 159
- Joined: Mon Dec 17, 2018 8:50 pm
- Location: UK
Re: Release Valve
many thanks. When I took the valve off, it was held in on only 3 threaded, PFTE tape and silicon gasket glue. Cleaned everything up, put the valve/ new diaphragm in less the spacer. Tested the valve and it works perfectly.ajscomboman wrote:Yes it's for the oil feed union.
Many thanks for the advice.