49 Model 18 Side Stand Fitting Spring question

Information relating to the Matchless G80 or AJS Model 18 500cc Heavyweight.
Locked
thackero
Posts: 6
Joined: Mon Feb 04, 2019 8:11 pm
Location: NSW AUSTRALIA

49 Model 18 Side Stand Fitting Spring question

Post by thackero »

I was given a side/kick stand with my 1949 AJS and I now have the correct spring however I am puzzled to how it fits. The lug on the frame is present so I can bolt the side stand on. Its the spring I am struggling with .
SPRIDDLER
Member
Posts: 8542
Joined: Wed Sep 01, 2004 1:00 am
Location: WEST SUSSEX UK

Re: 49 Model 18 Side Stand Fitting Spring question

Post by SPRIDDLER »

There are (should be) two holes in the bottom right hand frame rail. Use one and the stand will stay down, use the other and it will kick up when the bike is upright.
Have a look at this previous post:

http://www.jampot.com/forum/viewtopic.p ... ng#p197524
'There is a tide in the affairs of men
Which taken at the flood............'
thackero
Posts: 6
Joined: Mon Feb 04, 2019 8:11 pm
Location: NSW AUSTRALIA

Re: 49 Model 18 Side Stand Fitting Spring question

Post by thackero »

Spriddler,
I checked out the pictures from previous posts and still i am stumped. the 49 model 18 frame down tubes are different than the later tubes. I do not want to have to take paint off to find them . Does anyone have a same year and model that can give me a measurement so i can locate
Thanks
JimFitz
Posts: 663
Joined: Thu Feb 27, 2014 9:27 am
Location: Kent, England

Re: 49 Model 18 Side Stand Fitting Spring question

Post by JimFitz »

I gave up trying to find the spring holes on my 52 G80 rigid. A small right angle bracket on one of the lower engine studs on the right hand side did the trick. I have it so the stand stays down as I have found that a gust of wind when parked can cause it to spring up, also a nudge in the garage.

Jim
Too old to Rock and Roll but too young to die.

1952 G80 rigid, 1960 G12 DL / Watsonian Monza, 1954 G80S.
thackero
Posts: 6
Joined: Mon Feb 04, 2019 8:11 pm
Location: NSW AUSTRALIA

Re: 49 Model 18 Side Stand Fitting Spring question

Post by thackero »

Sorted thanks for your help.
Locked