Thought I'd try my luck in the G80 section as i got no response in G3.
Would anyone know the thread size for the engine oil feed pipe union extention http://www.amoc-parts.com/store/comersu ... duct=22695, not the thread that goes into the crankcase (1\4 bsp 19tpi), but the side that the pipe coming from the oil tank screws on?
Many thanks
Stuart
Oil feed union extention
-
- Member
- Posts: 50
- Joined: Fri Mar 16, 2012 6:18 pm
- Location: EAST SUSSEX UK
Oil feed union extention
g3l 1941
BMW r80G/S '82
Yamaha FZ750 '90(Project)
BMW r80G/S '82
Yamaha FZ750 '90(Project)
-
- Member
- Posts: 1439
- Joined: Sat Oct 09, 2010 9:17 pm
- Location: ABERTAWE UK
Re: Oil feed union extention
They a quiet crowd in the G3 section
I reckon it's 5/8 x 20 tpi (the thread that takes the nut, I have added a photo.
Colin
I reckon it's 5/8 x 20 tpi (the thread that takes the nut, I have added a photo.
Colin
only dead fish go with the flow
-
- Member
- Posts: 50
- Joined: Fri Mar 16, 2012 6:18 pm
- Location: EAST SUSSEX UK
Re: Oil feed union extention
Thanks Colin, I did wonder if it was a different thread to BSP as they go from 1/4" to 3/8", and it didn't fit a 3/8 helicoil i've got.
Cheers
Stuart
*Must get myself a thread gauge!
Cheers
Stuart
*Must get myself a thread gauge!
g3l 1941
BMW r80G/S '82
Yamaha FZ750 '90(Project)
BMW r80G/S '82
Yamaha FZ750 '90(Project)