primary chain gearbox adjuster

Information relating to the Matchless G11 or AJS Model 30 600cc twin
ajsph
Member
Posts: 326
Joined: Mon Jan 01, 1990 12:00 am
Location: DENMARK

Re: primary chain gearbox adjuster

Post by ajsph »

The studs I have shown is original a bolt, but I prefer a stud as it is easier to remove the stud
from the right side with the chaincase in situ. The with of the spacer is about 5/16
Regards Poul
User avatar
Rob Harknett
Member
Posts: 11236
Joined: Mon Jan 01, 1990 12:00 am
Location: ESSEX UK

Re: primary chain gearbox adjuster

Post by Rob Harknett »

g80csp11 wrote:Rob , must get down to specsavers my old glasses have gone out of adjustment
Don't go to spec savers, everything will look like my out of focus picture. If you complain, they say you need time to get used to the new glasses. If you go back a couple of weeks later. They will say, you only have the cheap vari focal lens ???
g5wqian
Member
Posts: 220
Joined: Wed Nov 18, 2015 7:43 am
Location: wiltshire
Location: near swindon wilts

Re: primary chain gearbox adjuster

Post by g5wqian »

thanks for the info Poul .
i have found a good place to get stainless fasteners from and they have studs in all kinds of sizes in 26tpi so ive ordered some bits from there to do the job , they only take paypal but that suits me fine , link below .

http://www.motalia.net/index.php?cPath=1

it may be stainless steel and not original but sorts my requirements out easily and it wont corrode .
great to be able to get the help i need from you lads .
regards
ian
Locked