I've just been reading a 1957 book "Motorcycle Maintenance and Repair" by F W Neill who is billed as the Service Manager of Associated Motor Cycles Ltd.
After going through the adjustment procedure for tappets and the usual .006"/.008 recommendations, he then says, and "I quote:"If speeds over 85 mph are not desired, rocker clearance can be reduced to nil for inlet and .002" for exhaust, with a cold engine."
Really? Any comments from people who know much more than I about these engines.
Tappet clerances on twins
-
- Posts: 15
- Joined: Sun Feb 22, 2009 3:16 pm
- Location: UK
- ajscomboman
- Member
- Posts: 3958
- Joined: Mon Jan 01, 1990 12:00 am
- Location: HAMPSHIRE UK
Re: Tappet clerances on twins
Post 60 twins .006 inlet and .008 exhaust for pre 60 models it's .006 for both inlet and exhaust. As for closing the gap down, not something I've ever tried or would recommend, ever.
-
- Member
- Posts: 2158
- Joined: Thu Jul 04, 2002 1:00 am
- Location: NORMANDIE FRANCE
Re: Tappet clerances on twins
My copy of Neill makes the same point somewhere. (As if an old 500 would even do 85 easily or at all!) But I have always gone with 6 and 8 (even on earlier engines) as it seems wise. They're not the quietest motors, and I suppose that's why the idea might appeal to some, but I wouldn't.