RH Rear Engine Plate

Information relating to the Matchless G15 or AJS Model 33 750cc twin. This also includes the G15 Mk II and the G15/45
Member
User avatar
Posts: 3277
Joined: Mon Jan 01, 1990 12:00 am
Location: HAMPSHIRE UK

Re: RH Rear Engine Plate

Postby ajscomboman » Sat Aug 15, 2020 4:12 pm

Just had a shower so stopped for the night but will be out there tomorrow so will do it then.

Member
User avatar
Posts: 3277
Joined: Mon Jan 01, 1990 12:00 am
Location: HAMPSHIRE UK

Re: RH Rear Engine Plate

Postby ajscomboman » Sun Aug 16, 2020 10:35 am

Mick as best as I can drive side measures .739" and the timing side .763"

Member
Online
Posts: 2494
Joined: Mon Mar 24, 2014 5:44 pm
Location: Aberdeenshire

Re: RH Rear Engine Plate

Postby Mick D » Sun Aug 16, 2020 12:58 pm

Thanks Rob

Another step closer to sorting out the basics - my replacement spacers are 0.770" drive side and 0.807" timing side.

When forced to fit the footrest bar nuts could not thread on fully.

With the centre stand stud, bushes and spacer snugged up and the front engine plates and spacers installed there was no way the footrest bar spacers would fit.

Your response points to the spacers being at fault so I'll jig up the components and adjust the spacers accordingly.

For what its worth, the spacer for the rear loop bottom stud is looking more and more like it would suit being fitted between the down tube lug and bottom rail on the LH side - I'll post some photos when it's all jigged up.

Regards Mick

Previous

Return to G15 / AJS Model 33

Who is online

Users browsing this forum: No registered users and 3 guests