RH Rear Engine Plate

Information relating to the Matchless G15 or AJS Model 33 750cc twin. This also includes the G15 Mk II and the G15/45
User avatar
ajscomboman
Member
Posts: 3963
Joined: Mon Jan 01, 1990 12:00 am
Location: HAMPSHIRE UK

Re: RH Rear Engine Plate

Post by ajscomboman »

Just had a shower so stopped for the night but will be out there tomorrow so will do it then.
User avatar
ajscomboman
Member
Posts: 3963
Joined: Mon Jan 01, 1990 12:00 am
Location: HAMPSHIRE UK

Re: RH Rear Engine Plate

Post by ajscomboman »

Mick as best as I can drive side measures .739" and the timing side .763"
Mick D
Posts: 2886
Joined: Mon Mar 24, 2014 5:44 pm
Location: Aberdeenshire

Re: RH Rear Engine Plate

Post by Mick D »

Thanks Rob

Another step closer to sorting out the basics - my replacement spacers are 0.770" drive side and 0.807" timing side.

When forced to fit the footrest bar nuts could not thread on fully.

With the centre stand stud, bushes and spacer snugged up and the front engine plates and spacers installed there was no way the footrest bar spacers would fit.

Your response points to the spacers being at fault so I'll jig up the components and adjust the spacers accordingly.

For what its worth, the spacer for the rear loop bottom stud is looking more and more like it would suit being fitted between the down tube lug and bottom rail on the LH side - I'll post some photos when it's all jigged up.

Regards Mick
Locked