"Tilt upwards the right-hand side of rocker box and extract the two long pushrods. Lay these aside so they may be identified because, although identical in
design, they should not be interchanged."Text
I did not know that as per above which is written in the maintenance manual, i really do not remember which one fit where, what will be the consequences if they were interchanged.
Push Roads 1941 G3L
-
- Posts: 16
- Joined: Sun Dec 20, 2009 1:23 pm
- Location: Sindh PAKISTAN
Push Roads 1941 G3L
Change is the only thing that constant
- Rob Harknett
- Member
- Posts: 11236
- Joined: Mon Jan 01, 1990 12:00 am
- Location: ESSEX UK
Push Roads 1941 G3L
The push rods are identical, they may wear/bed in differently, they will surely have the tappets set different, so if you slacken off the longest to the shortest , that will stop you tightening the rocker box down against spring preasure.
-
- Posts: 16
- Joined: Sun Dec 20, 2009 1:23 pm
- Location: Sindh PAKISTAN
Push Roads 1941 G3L
thanks Rob.
Assembling will be start after two weeks, and then i will start asking again
Assembling will be start after two weeks, and then i will start asking again
Change is the only thing that constant