Lower Fork Yoke Pinch Bolt
5 posts
• Page 1 of 1
Lower Fork Yoke Pinch Bolt
Could anyone tell me the length of the 3/8 BSF allen pinch bolt on the lower fork yoke on the 1 1/8th forks - part number 018649.
I screwed in one of the ones I was given and it was too short and just pulled the first couple of threads in the yoke.
Cheers
Martin
I screwed in one of the ones I was given and it was too short and just pulled the first couple of threads in the yoke.
Cheers
Martin
Re: Lower Fork Yoke Pinch Bolt
I agree with you the hole is deep enough for an inch and half bolt but it may need tapping out further.
Colin
Colin
only dead fish go with the flow
Re: Lower Fork Yoke Pinch Bolt
I bought some 3/8 x 3" unc allen bots in stainless - these had an 1 1/2" of plain shank on which I cut a BSF thread. I finished the length off at 1 7/16" and they work a treat.
I don't understand why 1" bolts are supplied as the thread contact is so minimal.
Cheers
I don't understand why 1" bolts are supplied as the thread contact is so minimal.
Cheers
5 posts
• Page 1 of 1
Who is online
Users browsing this forum: clive and 15 guests