l was out on the bike for about 2 hours, when I touched the carb body it was very hot. Should there be a thick fibre
gasket between carb and engine
Thanks
1937 AJS 250
-
- Posts: 94
- Joined: Fri Nov 30, 2012 2:42 pm
- Location: RENFREWSHIRE UK
- Rob Harknett
- Member
- Posts: 11211
- Joined: Mon Jan 01, 1990 12:00 am
- Location: ESSEX UK
Re: 1937 AJS 250
Just a normal paper gasket. You should notice the stud's are not long enough to take a spacer
-
- Posts: 94
- Joined: Fri Nov 30, 2012 2:42 pm
- Location: RENFREWSHIRE UK
Re: 1937 AJS 250
Thanks again for your reply
- griffin
- Member
- Posts: 207
- Joined: Thu Jan 01, 1998 12:00 am
- Location: NOTTINGHAMSHIRE UK
Re: 1937 AJS 250
Norman did you check the carb immediately after a run and killing the engine or was 5 minutes later ? I would have thought the carb would be fairly cool with a vacuum and vaporised fuel .
- Duncan
- Member
- Posts: 2145
- Joined: Thu Jul 10, 2003 1:00 am
- Location: HAMPSHIRE UK
Re: 1937 AJS 250
Pre-monobloc's do run hot and rely on the fibre washers on the float chamber for insulating the fuel, if you look at early post war singles they had an alloy extension/spacer on the head until the monobloc was introduced when they went to a Tufnell/insulating spacer
-
- Posts: 38
- Joined: Tue Feb 03, 2009 3:06 pm
- Location: LEICESTERSHIRE UK
Re: 1937 AJS 250
Hi Norman
I have the same bike 37/22 and the carb does run very hot, i've not experienced any problems through it though. What fuel do you use just out of interest? (not that that is anything to do with it)
I have just filled up with super unleaded after reading on here that it helps reduce pinking..... Save your money, it doesn't 😆😆😆
Andy
I have the same bike 37/22 and the carb does run very hot, i've not experienced any problems through it though. What fuel do you use just out of interest? (not that that is anything to do with it)
I have just filled up with super unleaded after reading on here that it helps reduce pinking..... Save your money, it doesn't 😆😆😆
Andy
- Rob Harknett
- Member
- Posts: 11211
- Joined: Mon Jan 01, 1990 12:00 am
- Location: ESSEX UK
Re: 1937 AJS 250
Remember, 1936 fuel was about 76 octane. It would not need high octane fuel to stop it pinking, unless you have fitted a very high comp. piston. The engine is more like an old tractor engine farmers would start on petrol then switch to paraffin.. During the 1950's petrol rationing I tried running my 37/26 on paraffin. It needed petrol to start it and warm it up first. It did not go very fast, I never went very far as it was making so much smoke.
-
- Posts: 857
- Joined: Tue May 27, 2008 2:19 pm
- Location: SURREY UK
Re: 1937 AJS 250
My Dad used to run his 1200 Indian on such a mixture. I remember sitting in the sidecar with the other 4 kids and seeing the cylinders glowing red. He used to complain that it melted his wellies. But we had transport at a time most didn't.
Stan
Stan