Happy Monday
The work on my G3LS continues: dynamo fully rebuilt and back (thank you Peter de Kremer of Rutland), the gearbox is back in with damaged or worn parts replaced (thanks AJS&MOC for advice and parts).
I just need to finish the primary chain case reassembly.
Whilst reassembling the clutch, I noticed that both chain wheel bearing washers were the same thickness; both appear to be the thick variety 12-10-4.
The 'thin' washer is only about 1 millimetre thinner than the thick one and the bike has been running with the thick washers. I realise that Burman / AMC used different thickness washers for a reason, but as I already have two thick washers and no thin one, can anyone tell me what difference it will make if I use what I have?
Or should I just buy the thin one?
Thanks
Simon
Burman Clutch Chain Wheel Bearing Washer
-
- Member
- Posts: 123
- Joined: Sat Sep 19, 2020 10:26 pm
- Location: Northumberland, England
- Contact:
Burman Clutch Chain Wheel Bearing Washer
Thank God for Southby
-
- Member
- Posts: 123
- Joined: Sat Sep 19, 2020 10:26 pm
- Location: Northumberland, England
- Contact:
Re: Burman Clutch Chain Wheel Bearing Washer
Update...
The thinner one is on order from the club spares shop.
Normally I'd expect to replace these as a pair, but the thick ones I have are in excellent shape.
Simon
The thinner one is on order from the club spares shop.
Normally I'd expect to replace these as a pair, but the thick ones I have are in excellent shape.
Simon
Thank God for Southby