G2 CSR Steering bump stops!?!
- Biscuit
- Deceased
- Posts: 3924
- Joined: Thu Jan 01, 1998 12:00 am
- Location: KENT UK
G2 CSR Steering bump stops!?!
The straight, centre portion is 5" long, that is between the beginning of the bends. The handlebars I bought from Armours struck the tank at full lock, replaced them from 'bars bought from JSL and the were fine.
-
- Posts: 7721
- Joined: Tue Nov 22, 2005 6:01 pm
- Location: UK
G2 CSR Steering bump stops!?!
right, no point in putting a photo up.
the easiest way to fit a bump stop is to ustilise that hole on the down tube and use a couple of penny washers, the big ones you can get ought to provide enough clearance and you can work it out from there.
Its what I use on my rigid as the check springs foul the tank otherwise
the easiest way to fit a bump stop is to ustilise that hole on the down tube and use a couple of penny washers, the big ones you can get ought to provide enough clearance and you can work it out from there.
Its what I use on my rigid as the check springs foul the tank otherwise
-
- Posts: 141
- Joined: Sat Jan 15, 2005 12:00 am
- Location: STAFFORDSHIRE UK
G2 CSR Steering bump stops!?!
The distance between the bends is 5", the same as yours itma. If I bolt washers as you say Ken then the yoke will probably miss them, they would have to be quite large penny ones. I`ll take photo and e-mail it to you to show you what I mean, if that`s possible.
-
- Posts: 141
- Joined: Sat Jan 15, 2005 12:00 am
- Location: STAFFORDSHIRE UK
G2 CSR Steering bump stops!?!
The distance between the bends is 5", the same as yours itma. If I use bolt washers as you say Ken then the yoke will probably miss them, they would have to be quite large penny ones. I`ll take photo and e-mail it to you to show you what I mean, if that`s possible.