Pushrod Tube Seals - I'm confused
-
- Member
- Posts: 1102
- Joined: Tue Jan 15, 2008 4:18 pm
- Location: SOMERSET UK
Pushrod Tube Seals - I'm confused
Many thanks i 've got the gasket set from the club will the cylinder head gasket need to be annealed,Thanks again.
Mike
- Biscuit
- Deceased
- Posts: 3924
- Joined: Thu Jan 01, 1998 12:00 am
- Location: KENT UK
Pushrod Tube Seals - I'm confused
The washer 016944 fits concave side down. When you put the cylinder head on you will find the pushrod tube rubber seals will cause the head to be lopsided. Screw down the head bolts adjacent to the pushrod tubes while observing the gap between head and gasket, when the gap is equal all round start tightening in sequence.
-
- Member
- Posts: 1102
- Joined: Tue Jan 15, 2008 4:18 pm
- Location: SOMERSET UK
Pushrod Tube Seals - I'm confused
Alan,Many thanks for your input,i have fitted pushrod tubes as your advise,I maybe one of the many clueless,but with the right guidance the job can be done.Thanks again,Dont give up hope,I will mention you in dispatches,as the knowledgable one.Maybe a message for all the guys who give advise, Be patient, we DO listen.We are after all after the same thing putting memories back on the road.Thanks again,Mike
Mike