Rockers 500 twin

Skorstad · Post by **Skorstad** » Fri Sep 24, 2010 8:46 pm

I tought i sendt 3 pictures too this web side about this bendt rockers but i only found one.
This rocker is bendt but is not shown in this pictures,i will send some new pictures soon.

Skorstad · Post by **Skorstad** » Sun Oct 03, 2010 10:28 pm

Hi is there someone who now,s the right measurement on the valves seat.I have sent the top too a company in norway but they havent done top like this before and they are asking for right measure ment for the valves seat. (If they grind too much or too little in the seat) is there somewear i can find it on this club side ?
Twin- 500- 1953,

Skorstad · Post by **Skorstad** » Tue Nov 23, 2010 6:24 pm

Skorstad · Post by **Skorstad** » Tue Nov 23, 2010 6:37 pm

Hi i got my valve top back from the company,and i put the top on the engine again,evrything looks fine until i start the engine, the ticking noise was back.
I think it,s come from the valve.
I have done some reading and the cam followers can make this noise if they are prone.

Is there someone who had the same problem ?

GSAX1 · Post by **GSAX1** » Wed Nov 24, 2010 7:47 am

Hi Skorstad.

Worn cam followers will make a loud clicking noise. Cam follower wear is very common on these early twins. The new followers available from the club spares scheme are made of better material and do not wear excessively.

Michael