Howdy all, Just removed head and barrel to discover wayward circlips and their grooves in the cyl wall. So I need to either bore and sleeve and new piston, rings, etc. Or s/h barrel and piston, or dare I say, (new) barrel and piston etc. 1958 G2. Damage too bad to bore oversize. Any advice on where to start looking? I am going to the Bristol Bike Show sunday, I was just going for some nuts and bolts but now!!
Regards Rod.
G2 engine parts
-
- Posts: 54
- Joined: Fri Dec 25, 2009 2:46 pm
- Location: MONMOUTHSHIRE UK
-
- Member
- Posts: 2882
- Joined: Mon Jan 01, 1990 12:00 am
- Location: USA USA
G2 engine parts
Whatever you find, make sure the circlips & grooves in the piston match. AMC used different type the wire ones used by most & cannot be swapped. Cheers, Don.
-
- Member
- Posts: 2882
- Joined: Mon Jan 01, 1990 12:00 am
- Location: USA USA
G2 engine parts
Whatever you find, make sure the circlips & grooves in the piston match. AMC used different type the wire ones used by most & cannot be swapped. Cheers, Don.
-
- Member
- Posts: 1906
- Joined: Wed Jan 01, 1992 12:00 am
- Location: SURREY UK
G2 engine parts
A bit early to be hitting the wine bottle isn't it Don
-
- Member
- Posts: 2882
- Joined: Mon Jan 01, 1990 12:00 am
- Location: USA USA
G2 engine parts
Neff'r tooo err-ly, Hic! Chreeesh! Don.
- rex.webb
- Member
- Posts: 2947
- Joined: Mon Jan 01, 1990 12:00 am
- Location: CAMBRIDGESHIRE UK
G2 engine parts
I have just returrnneedd from a Winnnee Tasting calllled Taste of france.Gooood it was. Now to beeddddebys.
r w webb