part no's

[4591yelrah1]

tried to order parts from parts book but no's don;t tally with parts suplyers no's?

[Rob Harknett]

What parts & numbers also what year and model bike, also what supplier ? Over the years part numbers were changed a few times, so if its an old pt. no. you will have to convert the part number to the later part number. Please answer the questions so I can help you.

[4591yelrah1]

using origonal parts book for g2 and amoc parts dont recognise no's

[4591yelrah1]

using origonal parts book for 1959 g2 and amoc parts dont recognise no's

[Rob Harknett]

The 1959 G2 part numbers will be OK also the club part numbers should match those in the parts book.
If you cannot find part numbers for the parts you want, in the club spares list, this means the club does not have that part.
But you did not give the numbers of the parts you want for me to check for you. Maybe I could find them listed if you were looking in the wrong place. At least I could confirm the part number were correct and we stock, or do not stock the parts you want.

[4591yelrah1]

rear wheel spindle lock nuts 043305 and hub bearing
> felt seal 043300

[Ozmadman]

using origonal parts book for 1959 g2 and amoc parts dont recognise no's

Hi Billy

Take up Rob's offer to help you with the numbers you want , he's a helpful guy as we all are here

Paul

[Rob Harknett]

The part numbers are OK, the reason you could not find them in club spares was not because they were not recognised . No data found means they are not sold by the club
Felt seal 043300 has never been stocked. Other members are cutting them from felt,
you may need 2/3 pieces to make up the thickness of the seal. Rear spindle lock nut 043305 came up no data found as this part is out of stock. You will need 2 of these. If you have old ones check the thead size dia. I believe is 26 PPI cycle thread. You may be able to use a standard nut, perhaps cut down so its thinner.

[4591yelrah1]

1ts 9/16 26 tp1 cycle anybody know the width please

[Rob Harknett]

I will look in the morning, emm its 1.30am now, bit later in morning I think.