AJS Model 22 250 1937
Posted: Wed Jan 13, 2016 9:21 am
Can anyone help .
My little 250 big end gave out on the VMCC club run Boxing Day just as we got to the pub.
I'm looking for parts..
Piston and rings+20 and either a new big end or second hand crank.
So far I've had no luck tracing parts.
I have been told an early 350 engine would go in?
I would fit either 250 or 350 as I have a 350 CP gearbox fitted.
The bike was a barn find and has been restored to a competition style bike.
Any and all help and advice greatly appreciated.
Im currently restoring a 18s 1954 500 single, once complete i will strip the 250 engine down. 500 is nearly done.
Crank pin broken, looks like big end maybe ok.
Pin measures 3/4" diameter. Anyone know where I could obtain one?
Big end is u/s, but I can machine a pin from EN24T, but I still need a big end bearing. Anyone have any alternatives to the standard bearing or where I can obtain a drilled inner bearing sleeve. I.D 3/4 O/D 31/64"
Nightmare outside Dia.
Thanks
Clive
My little 250 big end gave out on the VMCC club run Boxing Day just as we got to the pub.
I'm looking for parts..
Piston and rings+20 and either a new big end or second hand crank.
So far I've had no luck tracing parts.
I have been told an early 350 engine would go in?
I would fit either 250 or 350 as I have a 350 CP gearbox fitted.
The bike was a barn find and has been restored to a competition style bike.
Any and all help and advice greatly appreciated.
Im currently restoring a 18s 1954 500 single, once complete i will strip the 250 engine down. 500 is nearly done.
Crank pin broken, looks like big end maybe ok.
Pin measures 3/4" diameter. Anyone know where I could obtain one?
Big end is u/s, but I can machine a pin from EN24T, but I still need a big end bearing. Anyone have any alternatives to the standard bearing or where I can obtain a drilled inner bearing sleeve. I.D 3/4 O/D 31/64"
Nightmare outside Dia.
Thanks
Clive