Spacer and collar betwen bearings
Posted: Thu Mar 02, 2017 6:07 pm
Hi everybody
As I'm rebuilding my engine (finaly) 194I G3L wonder if anyone have the correct measurement for the washer and the spacing collar betwen the two main ballbearings. SKF RLS8.
This engine has been manhandled in India, so what was in there when i took it apart, was certainly not the right stuff. I allso would like to know about the material. Steel or bronze.
I ask this because I'm on a limited budget, and have to save where I can. Given the right specs, I will fabricate these myself and thus save a little
Cheers
As I'm rebuilding my engine (finaly) 194I G3L wonder if anyone have the correct measurement for the washer and the spacing collar betwen the two main ballbearings. SKF RLS8.
This engine has been manhandled in India, so what was in there when i took it apart, was certainly not the right stuff. I allso would like to know about the material. Steel or bronze.
I ask this because I'm on a limited budget, and have to save where I can. Given the right specs, I will fabricate these myself and thus save a little
Cheers