Page 1 of 1
Another Query - Alternator Wires
Posted: Sat Sep 29, 2018 7:12 pm
by moley
Hi All
I have an alternator with three different colour wires attached to it than was originaly on it
I need to trace which wire is which
Any Ideas ?
I recall the three of them are different !
Many THanks
Andy
Re: Another Query - Alternator Wires
Posted: Sat Sep 29, 2018 8:56 pm
by aobp11
In
this thread Colin Farrington tells how you can use resistance measurements for this.
I hesitate to say but it seems there is a mistake there.
Wire L/G is the "center tap" or "common" between a low power coil L/G - D/G and a high power coil (2 coils in parallel) L/G - G/Y. Hence I would expect L/G - G/Y to show the lowest resistance reading, L/G - D/G about twice that value, and D/G - G/Y about three times that value.
Albert
Re: Another Query - Alternator Wires
Posted: Sun Sep 30, 2018 5:10 pm
by raffles
Something to be learned every day I did not know that G11 or M30 had alternators I have only ever seen dynamos
Tony
Re: Another Query - Alternator Wires
Posted: Sun Sep 30, 2018 5:38 pm
by moley
Thanks Albert very helpful
Hi Tony , the bike I am working on is a bitza - I would say the frame is 54 and has g9 crankcases but G11 barrels !!
Cheers
Andy
Re: Another Query - Alternator Wires
Posted: Tue Dec 04, 2018 2:30 pm
by PeterJCorby
Hey Moley, I used this link when doing my G12 12 volt conversion-m perhaps it will help you?
http://www.norbsa02.freeuk.com/goffyalt ... wiring.htm