Oiling swinging arm
Posted: Sat May 04, 2019 5:12 pm
I needed to do this and recently have used a hypo body and SAE 50 - incorrect I know but what I had.
After a trip to Smith & Allans at Darlington to get engine oil and grease ( because the 25 litre drum of the former nearly empty) I bought some SAE140.
Also found Dad had left me an early one of these https://us.misumi-ec.com/vona2/detail/223006026854/ a Super Jet Oiler.
Matchless on side stand, little screw out, reasonable warm day. Measure in to 100 mark on the bottle although no idea what that meant but so I could see how much I got in. Very little. I know there's little space between the cover and the bush / shaft, I put it in years ago and progress on this often slow. I can only thing that the SAE50 is still in there. Surely not.
There's no play on the s/arm.
Perhaps go back to using the blunt hypo with it's wider nozzle jammed into the orifice so acts a bit like a gun.
Ho hum.
Johnny B
After a trip to Smith & Allans at Darlington to get engine oil and grease ( because the 25 litre drum of the former nearly empty) I bought some SAE140.
Also found Dad had left me an early one of these https://us.misumi-ec.com/vona2/detail/223006026854/ a Super Jet Oiler.
Matchless on side stand, little screw out, reasonable warm day. Measure in to 100 mark on the bottle although no idea what that meant but so I could see how much I got in. Very little. I know there's little space between the cover and the bush / shaft, I put it in years ago and progress on this often slow. I can only thing that the SAE50 is still in there. Surely not.
There's no play on the s/arm.
Perhaps go back to using the blunt hypo with it's wider nozzle jammed into the orifice so acts a bit like a gun.
Ho hum.
Johnny B