Page 1 of 1

62 g3 ignition switch

Posted: Sat Jul 27, 2019 8:42 pm
by moley
Hi Al

My battery goes down after a while so I thought I would add
A flick switch in the earth wire to the battery .

All went fine and until the flick switch is in the correct position the lights won't come on

But

With the battery insulated I turned the ignition switch to the right and the bike started
Which makes me think I have always ran the bike on emergency ?

On coil ignition switch ( the small switch not the large prs8 switch ) which way is normal running ?

Cheers

Andy

Re: 62 g3 ignition switch

Posted: Sat Jul 27, 2019 11:07 pm
by Rob Harknett
Is it not marked E & I. My Wipac L/Weight are. I would have thought coil H/W Lucas would also be marked. Just looked. It will tell you in your bikes instruction book. The switch positions should be marked. You may also read, if your battery is dead, use emergency position, but switch to Ing. once the bike is started, or miss firing will occur.

Re: 62 g3 ignition switch

Posted: Sun Jul 28, 2019 6:01 am
by Mick D
Hi

The Lucas 63SA ignition switch should be wired so as turning clockwise from the central position puts the circuit into normal running mode, (IGN), turning it anti clockwise puts it into emergency, (EMG). Is this the switch you have?
63SA.png
Regards Mick