G9 1953 Noise
Posted: Sat Dec 21, 2019 12:46 pm
I wonder, which clearance is allowed on cam-followers sideways, G9 1953, I can move them 2-3 mm.
I´m asking because there is a noise in the area at the cylinder base or crankcase (timing-case), I suspect cam-followers or that the timing gears are making the noise (rattle).
I also attached a photo on the push rods, I do not know if the damage is fresh or if it is old damage. What might have caused this?
A.Rydén
Sweden
I´m asking because there is a noise in the area at the cylinder base or crankcase (timing-case), I suspect cam-followers or that the timing gears are making the noise (rattle).
I also attached a photo on the push rods, I do not know if the damage is fresh or if it is old damage. What might have caused this?
A.Rydén
Sweden