AJS & Matchless Owners Club

Hi All, once again on a quest to find tail light mounting diagram/drawing. I have the number plate and light but unable to see how it is mounted to the rear mudguards.
Any close-up or diagrams would be greatly appreciated.
Regards Roger

Fixed like this !

There should be a bracket at the bottom of the number plate where there it would attach with two BA screws up to the fairing part of the unit there should be welded in from the left to the right a 5/8th or so bracket with a square hole for one of those little sprung caged square nuts. So a bolt up through the mudguard screws into this captured nut.
Hope I'm not stating the obvious

g80csp11 wrote:

tail light.jpg

Fixed like this !

I was told earlier that I couldn't list this question.
Thanks very much.
There doesn't seem to be anything on the tail light assembly.
Regards Roger

Martin.S wrote:There should be a bracket at the bottom of the number plate where there it would attach with two BA screws up to the fairing part of the unit there should be welded in from the left to the right a 5/8th or so bracket with a square hole for one of those little sprung caged square nuts. So a bolt up through the mudguard screws into this captured nut.
Hope I'm not stating the obvious

I have the number plate and a bracket which is bolted to the mudguard.
The shroud that sits over the wires and attaches to the light assembly is missing. Not sure what it's called.
Many thanks for assistance
Roger

Mine is very similar to this

https://www.feked.com/number-plate-ajs- ... orton.html
https://www.feked.com/rear-lamp-lucas-679-type.html

although i don't use feked , show as example only

g80csp11 wrote:Mine is very similar to this

https://www.feked.com/number-plate-ajs- ... orton.html
https://www.feked.com/rear-lamp-lucas-679-type.html

although i don't use feked , show as example only

I now know what I need as the parts.
The problem is not knowing what I need and where to get them.
Thank you Peter.
Thank you all.
Roger