Hi all I can’t recall the depth of This soap et which sits between the crankcase bearing and the primary/dynamo sprocket . I have two and unsure which to use
I did research the previous posts but they are unsure
I did see 1/4 or .435 ?
Any help appreciated
Andu
021877 collar engine sprocket 55 g8s
-
- Member
- Posts: 560
- Joined: Sat Jan 01, 2000 12:00 am
- Location: EAST SUSSEX UK
- Joker_Bones
- Member
- Posts: 545
- Joined: Sat Apr 27, 2013 3:51 pm
- Location: DORSET UK
Re: 021877 collar engine sprocket 55 g8s
Thicknesses are discussed in this thread: viewtopic.php?p=247295#p247295
Assuming they are correct and by elimination
010629 <55 = 0.435"
023066 >57 = 0.265"
leaving... 021877 55-56 = 0.186"
I would suggest trial fitting the ones you have and see which one gives the best alignment between the sprockets.
Assuming they are correct and by elimination
010629 <55 = 0.435"
023066 >57 = 0.265"
leaving... 021877 55-56 = 0.186"
I would suggest trial fitting the ones you have and see which one gives the best alignment between the sprockets.