I have started to re-build the cylinder head on my 1960 350 Lightweight, and can`t find any information in any of the manuals I have in relation to what is the correct grinding angle for the inlet and exhaust valve seats.
Many thanks in advance.
350 Lightweight Valve Seats ?
- patchy-man
- Posts: 73
- Joined: Wed Mar 21, 2007 4:05 pm
- Location: FALKIRK UK
350 Lightweight Valve Seats ?
"How many is too many"
-
- Posts: 139
- Joined: Wed Oct 12, 2005 10:45 pm
- Location: CAMBS UK
350 Lightweight Valve Seats ?
Hi patchy man
I once had a 350 g5 lightweight if memory serves me right 45 degrees, are you recutting the seats? if not use the valves and lapping paste to grind them in check that the valves are not bent before you start
regards laurence
I once had a 350 g5 lightweight if memory serves me right 45 degrees, are you recutting the seats? if not use the valves and lapping paste to grind them in check that the valves are not bent before you start
regards laurence
- patchy-man
- Posts: 73
- Joined: Wed Mar 21, 2007 4:05 pm
- Location: FALKIRK UK
350 Lightweight Valve Seats ?
Thanks for the information Laurence. I should have said re-cutting the valve seats ?
Regards.
Regards.
"How many is too many"