G15 cylinder head and oiling
Posted: Tue Jun 05, 2007 2:13 pm
My G15 has note been usedmuch recently. On starting it now blows oil out of the breather. Suspecting a damaged bore I attempted to remove the cylinder head. Not easy even with the exhaust rockers out! There was not enough clearance to get the push rods far enough up and I ended up removing the head and barrel together. It can't go back together the same way!
The piston, rings and bore all look OK, very little wear. The bores look polished and have a slight a brownish tinge.
Suggestions please; should I just re-ring it? Is it possible to get the cylinder head back on without removing the whole engine/gearbox assembly?
The piston, rings and bore all look OK, very little wear. The bores look polished and have a slight a brownish tinge.
Suggestions please; should I just re-ring it? Is it possible to get the cylinder head back on without removing the whole engine/gearbox assembly?