speedo

lawrence · Post by **lawrence** » Thu May 22, 2008 5:46 pm

Ah, don't worry Dan. We'll get you sorted

danatkins · Post by **danatkins** » Thu May 22, 2008 8:41 pm

" Oh dear Dan, what have you done" hhhmmmmm that sounds bad.. what have I done?

TommoT · Post by **TommoT** » Thu May 22, 2008 9:20 pm

Dan I can't hide anymore, I have intimate knowledge of that particular motorcycle. The whole rear bearing, axle and spacer set-up is custom made in stainless steel, by the bloke who built it. Nice work'n all, but it makes it nay on impossible to use a standard set-up for a speedo gearbox. I would say you'd be better off, either getting another wheel in standard trim, or just go the electronic route. Fit a bicycle speedo and calibrate to suit. Also modern scooter stores sell electronic alternatives. Just my opinion, there may be other alternatives as well, depending how skilled a craftsman you are.

danatkins · Post by **danatkins** » Fri May 23, 2008 3:44 pm

Hi TommoT

Thanks for the reply, I was looking at it and I think you are right it would be a difficult job alright! I think the electronic route is the way to go. Thanks for the help..