Re-assembling crankcases of WD G3L

General purpose topics/chat goes in here
Locked
User avatar
Galea
Posts: 40
Joined: Tue Sep 16, 2008 1:17 pm
Location: Gozo MALTA

Re-assembling crankcases of WD G3L

Post by Galea »

I should soon be re-assembling the engine of my ex-WD G3L (at least that's the plan after getting the big-end done). Some questions:

1. What should be used to seal the crankcase halves together? I don't think they take a gasket.

2. Should there be a gasket between the crankcases and the compression plate? Or is the only gasket between the compression plate and the cylinder base?

3. How do I take apart the cylinder oil feed valve (ball, spring and plug) in the timing side crankcase for cleaning? Tried taking one out on a damaged crankcase and only succeeded in stripping the presumably BA threads in the brass plug.

Any other things I should watch out for? Thanks in advance for all your help.

Regards,

Joseph

itma
Posts: 7721
Joined: Tue Nov 22, 2005 6:01 pm
Location: UK

Re-assembling crankcases of WD G3L

Post by itma »

no gasket between the cases, I prefer Hylomar or Wellseal jonting sealant/

A paper gasket both sides of the compression plate;if its a thick one you will need the extra washers under the bottom pushrod seals.

the plug is tapped 3BA; insert a cheesehead screw and lever out;usually they come out easy, a bit of heat might help.

everything else is straight forward, make sure both washers are between the main bearings.
User avatar
Galea
Posts: 40
Joined: Tue Sep 16, 2008 1:17 pm
Location: Gozo MALTA

Re-assembling crankcases of WD G3L

Post by Galea »

Thanks for the advice
User avatar
Rick.Edwards
Deceased
Posts: 681
Joined: Thu Feb 27, 2003 12:00 am
Location: BEDFORDSHIRE UK

Re-assembling crankcases of WD G3L

Post by Rick.Edwards »

Nice Jeep.
The piston ring King
User avatar
Galea
Posts: 40
Joined: Tue Sep 16, 2008 1:17 pm
Location: Gozo MALTA

Re-assembling crankcases of WD G3L

Post by Galea »

Thanks, that's my 1942 Willys MB. It can be seen in the American section of
http://www.militaryvehicles.bravehost.com/

There are some interesting motorcycles in the British section as well
User avatar
Rick.Edwards
Deceased
Posts: 681
Joined: Thu Feb 27, 2003 12:00 am
Location: BEDFORDSHIRE UK

Re-assembling crankcases of WD G3L

Post by Rick.Edwards »

You have some interesting kit in your shed. incidently i have plenty of ex US WD piston rings from jeeps to the gennys on Sherman tanks. check my website thats being built. www.pistonringshop.co.uk
The piston ring King
User avatar
Galea
Posts: 40
Joined: Tue Sep 16, 2008 1:17 pm
Location: Gozo MALTA

Re-assembling crankcases of WD G3L

Post by Galea »

The only vehicle on that website which is mine is the jeep. The other vehicles belong to friends and acquaintances of mine (on such a small island almost all people with a common interest know each other!)
Locked