G15CSR Motor Mount Spacer Placement
Posted: Fri Feb 11, 2011 7:26 am
OK, on the bottom cross frame stud....the square one.... Part # 01-8604 (the one used for mounting the foot pegs on CS models)
There are 3 spacers
The first is the long one which is self-evident....it goes between the mounting plates
the other 2 are short ones going on the outside of the mounting plates. Between the frame's lower rails and respective plates
They are 2 different lengths meaning 1 goes on the Drive side and 1 goes on the Timing side
My Parts book describes them as follows: 03-0236 Spacer Left Hand and 01-0911 Spacer Right Hand
Can anyone advise me which side the SHORTER one goes on?
If I have the answer I should be able to figure the rest of it out
Thanks & regards
Gerard
There are 3 spacers
The first is the long one which is self-evident....it goes between the mounting plates
the other 2 are short ones going on the outside of the mounting plates. Between the frame's lower rails and respective plates
They are 2 different lengths meaning 1 goes on the Drive side and 1 goes on the Timing side
My Parts book describes them as follows: 03-0236 Spacer Left Hand and 01-0911 Spacer Right Hand
Can anyone advise me which side the SHORTER one goes on?
If I have the answer I should be able to figure the rest of it out
Thanks & regards
Gerard