Well, I thought I would have my gearbox rebuilt this afternoon.......Wrong!!
I have fitted the correct output bearing with the 6mm roller bearings but when I went to tighten the left hand thread nut for the sprocket, everything jammed up solid. After lots of trying I think the P/O has had the sleeve machine down by a few mm to allow for the incorrect bearing he fitted.
The depth of the sleeve is 6.5mm and I think it should be more like 8.5mm.
In addition it only just comes through the oil seal so, has anyone got one they could measure and save me losing the plot completely?
I did try the spares website but I couldn't see one listed. If anyone could help i would very grateful
Thanks all.
Sent from my SM-T720 using Tapatalk
Gearbox output sleeve.
-
- Posts: 12
- Joined: Sat Feb 29, 2020 11:21 am
- Location: Buckinghamshire UK
-
- Member
- Posts: 116
- Joined: Sat May 18, 2019 5:50 pm
- Location: Cheshire UK
Re: Gearbox output sleeve.
I rebuilt my gearbox satis overwinter with extensive problems. Take a look at clanger9 and vigo feb 20 gearbox might be something there.
Mike (vigo)
Mike (vigo)
- clanger9
- Posts: 1163
- Joined: Sat Jun 20, 2015 9:38 am
- Location: Chester, UK
Re: Gearbox output sleeve.
Yes, it's been machined down: it should be 10mm.
However, you're in luck - I have a spare you can have.
Send me a PM and I'll pop it in the post...
However, you're in luck - I have a spare you can have.
Send me a PM and I'll pop it in the post...
You do not have the required permissions to view the files attached to this post.
1989 Moto Morini Dart 350
1993 Ducati 750SS
1993 Ducati 750SS
-
- Posts: 12
- Joined: Sat Feb 29, 2020 11:21 am
- Location: Buckinghamshire UK
Re: Gearbox output sleeve.
Thanks mate, I've messaged you
Hopefully it should all slot back together now......I hope
Sent from my SM-T720 using Tapatalk
Hopefully it should all slot back together now......I hope
Sent from my SM-T720 using Tapatalk
-
- Member
- Posts: 32
- Joined: Sun Mar 29, 2020 11:37 am
- Location: Hertfordshire UK
Re: Gearbox output sleeve.
Hi Nigel, I assume you got the 6mm roller bearing from the club ?
John
John
-
- Posts: 12
- Joined: Sat Feb 29, 2020 11:21 am
- Location: Buckinghamshire UK
Re: Gearbox output sleeve.
Hi mate,beebike91 wrote:Hi Nigel, I assume you got the 6mm roller bearing from the club ?
John
Yes I brought it from the club. All back together now with a few mods to stop oil leaks.
Sent from my SM-T720 using Tapatalk